If the feeding speed is too fast, the load will increase and cause blockage. When feeding, you should always pay attention to the large deflection angle of the ammeter pointer. If the current exceeds the rated current, it means that the motor is over...

1. The feeding speed is too fast, the load increases, causing blockage During the feeding process, pay attention to the large deflection angle of the pointer of the ammeter at any time. If the current exceeds the rated current, it indicates that the ...

Note: the bearing bears all the loads of the machine, so satisfactory lubricating oil is crucial to the life of the bearing, which directly affects the life and operating rate of the machine, so the lubricating oil must be kept clean , Tightly sealed...

When working, put the material to be crushed into the machine from the hopper on the side of the machine casing, and rely on the grinding roller device suspended on the plum blossom frame of the main machine to revolve around the vertical axis and at...

1. Measurement positioning. The measurement and positioning of the powder mixer determines the longitudinal centerline of the mixer, that is, the axial centerline of the cylinder, and the transverse centerline is the radial centerline of the idler ro...

1. Pay attention to check and maintain the external body of the ribbon mixer, and regularly remove the dirt and obstacles on the horizontal ribbon mixer. 2. It is necessary to regularly check the oil, circuit and control equipment at each lubrication...

1. The principle of sufficiency Every process of the mixer avoids the waste of the process itself. For example, in the cutting process, the equipment can cut three boards at the same time, but it can be designed as two boards, and the hole position o...

Adding an air filter combination (usually called two or three parts) to the air inlet of the mixer can not only remove moisture in the compressed air, but also lubricate the solenoid valve and cylinder of the mixer and protect the pneumatic component...

1. Check that the power supply of the ribbon mixer meets the requirements, mainly to see its voltage; after connecting the power supply equipment, observe whether the direction of the auger in the mixer is correct and whether it violates the standard...

① Be sure to follow the operating procedures of the equipment, which is the best maintenance for the equipment. ② Note that after the equipment is started normally, then feed and mix, and the feed should be added slowly according to the required orde...

1. The design of the mixing cylinder of 3D mixer is unique, the inner wall of the body is precisely polished, there is no dead angle, and the material is not polluted. The material is easy to clean and so on; 2. Small vibration, low noise, adjustable...

1. When loading and unloading, the electric motor of the 3D mixer must be stopped to prevent electrical failure and unnecessary accidents; 2. The mixing of 3D mixer is three-dimensional space mixing, and a safety protection fence is added within the ...

1. First of all, it is necessary to observe whether the direction of rotation of the auger of the mixer is correct. If the direction of rotation does not meet the requirements, we must immediately adjust it, otherwise the products mixed by the mixer ...

Mixing methods also include artesian mixing and mechanical mixing. Self-flow mixing refers to the movement between materials, which achieves uniform mixing through self-friction, and mechanical mixing refers to the uniform mixing of materials through...

1. Open the feed port of the mixer, and reconfirm that the discharge port is closed, and put a specified amount of material into the V-shaped hopper according to the process control requirements. the 2. After feeding, close the feeding port and lock ...