Repair and replacement of the sieve of the powder machine: the sieve is made of steel sheet or iron bar. When the screen is damaged or penetrated by debris, if the damage is small, it can be repaired by riveting or welding; if it is damaged in a larg...

The pulverizer motor has been sealed before shipment, and the coupling has been calibrated. The spice pulverizer manufacturer pointed out that please do not loosen it; remove the iron debris on the claw pole cylinder and the claw pole plate of the pu...

Check the running position of the blade, from the position of the feed port. The blade should run in the opposite direction, otherwise the motor wiring should be adjusted; before feeding, the machine should be idling for 30 minutes, and then feeding ...

Most customers choose the type of equipment based on the type of material so that it can operate more efficiently. The types of materials include crushability and relative density. The pulverization of materials has a great influence on the disposal ...

The pulverizer and power equipment should be securely assembled. If the pulverizer runs stationary for a long time, it should be fixed on the concrete foundation; if the food pulverizer is in mobile operation, the equipment should be assembled on the...

Residual miscellaneous materials, the materials are crushed by the crushing equipment, and the whole process of production and processing is extremely coherent, which may constitute continuous waste and crushing. In this way, the production and proce...

1. The feeding speed is too fast, the load becomes larger, causing blockage. In the feeding process, it is necessary to pay attention to the large offset angle of the ammeter pointer in time. If it is higher than the rated current, it will reflect th...

The food grinder and drive unit should be installed firmly. If the pulverizer is fixed for a long time, it should be stabilized on the basis of cement; if the pulverizer is a mobile operation, the unit should be installed on the base made of angle ir...

The spice grinder should be cleaned after every 300 hours of operation. If the bearing is lubricated by oil, it is advisable to fill 1/3 of the bearing seat gap when adding new oil, and it should not exceed 1/2 at most. Just tighten the cover of the ...

1. Before use, an idling test run shall be carried out. Before the test run, the firmness of all connectors of the horizontal V-type mixer, the amount of lubricating oil in the reducer and the integrity of electrical equipment shall be checked. Then,...

V mixer series products are efficient asymmetric mixers, which are suitable for mixing powder or granular materials in chemical, food, medicine, feed, ceramics, metallurgy and other industries. The machine is reasonable in structure, simple in operat...

It is widely used for mixing powder and powder (solid liquid) in chemical industry, pesticide, dye, food, feed, building materials, rare earth, etc. The machine has wide adaptability to mixed materials, and will not overheat heat sensitive materials,...

Three dimensional mixer is a machine that uses mechanical force and gravity to evenly mix two or more kinds of materials. Hybrid machinery is widely used in various industries and daily life. The three-dimensional mixer can mix a variety of materials...

They have different characteristics and uses. From the perspective of mixing effect, three-dimensional and biconical mixing effect is the best, but the price is expensive. Each loading is less, followed by V-type mixer, which is moderate in price. Th...

Concrete mixer is a machine that mixes cement, sand aggregate and water into concrete mixture. It is mainly composed of mixing drum, feeding and unloading mechanism, water supply system, prime mover, transmission mechanism, frame and supporting devic...