The pulverizer motor has been sealed before shipment, and the coupling has been calibrated. The spice pulverizer manufacturer pointed out that please do not loosen it; remove the iron debris on the claw pole cylinder and the claw pole plate of the pulverizer feeding hopper on time; check the broken products on time. Granularity; regular maintenance of relay operation (to see if it works correctly).

Regularly maintain the damage degree of each structural component of the pulverizer to see if it belongs to the correct damage; always pay attention to the vibration status of the pulverizer; when the hammer of the pulverizer is obviously damaged and needs to be replaced, pay attention to the weighing to ensure that the two correspond ( 800 azimuth) the net weight difference between the corresponding two hammers on the hammer shaft pin is ≤ g and the total weight difference between the two corresponding hammer shaft pins (800 azimuth) is ≤ 2g; when the crusher screen is obviously damaged and needs to be replaced, it must be Pay attention to whether the flatness of the new screen and the specifications of the screen are correct, and whether the installation is qualified. When installing, let the rough surface of the screen wash in.

The opening degree of the supplementary air valve of the wind wheel feeding hopper should be adjusted properly; if abnormal phenomena such as large vibration and high noise of the pulverizer are found, it should be shut down immediately for inspection; after the spindle runs for 40 hours, 80 grams of lubricating oil should be added, but only 60%, after 800 hours of operation, the bushing cover should be removed and all the lubricating oil used should be replaced. The spice grinder manufacturer pointed out that when changing into fresh lubricating oil, add lubricating oil to the surrounding area of the roller bearing and the shaft ring, and add /3~/2 lubricating oil to the bottom shell, it is best not to add too much lubrication Oil; when it is found that the production capacity of the pulverizer is suddenly reduced, in addition to the factors of the material, it is necessary to check whether the air supply valve is qualified, whether the pipeline is ventilated, whether the discharge port is blocked, whether the relay and fan are operating correctly, etc.