Pulverizers are mainly used in pharmaceuticals, chemical plants, smelting, food, housing construction and other fields. Protection and maintenance of the food grinder: Before application, check whether all the standard parts of the equipment are tightened and the transmission belt is not tightened. The operating angle of the electro-spindle must conform to the dotted line angle shown on the protective cover, otherwise the equipment will be damaged and life may be damaged. Check that the device is complete. Check whether there are rigid impurities such as alloys in the crushing chamber of the equipment, otherwise it will damage the blade and interfere with the operation of the equipment. The content of the material must be checked before crushing, and alloy hard impurities are not allowed to infiltrate, so as to prevent accidents such as damaging the blade or causing burns. The oil mark on the equipment should be filled with grease from time to time to ensure the normal operation of the equipment.

Suspend feeding before shutting down. If it is not used continuously, clean up the residues in the machine. Check the blade and mesh screen for damage on time. If damaged, it should be replaced immediately. The body will vibrate slightly during application. Be sure to tighten the cover connection handle to prevent safety accidents. Food shredders also usually use a motor to directly connect the shredding equipment, and this type of connection is simple and easy to maintain. The rotor is different from the grinder rotor. The motor can be moved left or right, or the motor can be raised to adjust the coaxiality of the two rotors.

Pulverizer rotor discriminating heart. The reason for this is that the two supporting surfaces that support the rotor shaft are not in the same surface. A copper sheet can be placed on the bottom edge of the support bearing seat, or an adjustable wedge iron can be added to the bottom end of the bearing to ensure that the two shaft heads are shared. The crushing mechanism vibrates a lot. The reason is that the connection between the coupling and the rotor is discriminated or the quality of the flat hammer inside the rotor is not uniform. The connection between the coupling and the motor can be adjusted according to the difference between the coupling and the motor: when the quality of the hammers is uneven, a set of hammers must be selected again to make the relatively symmetrical hammers and the relatively symmetrical hammers error. less than 5G. The protection and maintenance of the pulverizer is completed, which can improve the application period of the equipment and have a better guarantee in the processing link.