The operation method of the mixer is as follows:

1. The modern control system of this horizontal ribbon mixer is becoming more and more complex, which brings great benefits and simplified operation. When implemented properly, the cost of programmable logic controllers has been reduced to the point where the technology is often used to economic advantage. If you don't, nothing will go away. High and low temperature alarms, motor status indicators, pressure and motion switches are often included in relay logic control panels.

2. Familiar with the program or hard-wired mode and its logic. Frequent blown fuses. Some instruments fail due to faults, and the system does not alarm. The wires can come loose and should close when the circuit is open. Under operating conditions, there are many control failures that can lead to poor operation. Familiarity with the logic of the control system is important to successfully eliminating poor performance.

3. Every operator must emphasize that even if the performance has changed a lot, the actual content has not changed. So much can be changed! For example, in classification preprocessing, the screen size increases due to not having a correct backup screen.

The reducer of the mixer needs to be replaced with new oil every three months, which is often used. When replacing, clean the reducer and add new oil.

The inspection parts are worm gear, worm, bearing and oil seal, which should be inspected regularly once or twice a month. Whether the operating parts are flexible, whether the fasteners are loose, and any abnormalities should be dealt with in time.

If you find that the 3D mixer vibrates abnormally or makes abnormal sounds during use. Shut down immediately for inspection.

If a fault is found, it should be repaired in time. Electrical control parts should be kept clean and sensitive.

The well-mixed mud should be dismantled, installed stably, and placed with care to avoid deformation and damage.

Residual material should be cleaned from all parts of the machine. The mixer disperser mixer emulsifier disperser has been out of service for a long time, and all machines need to be wiped and cleaned, and the surface of the parts should be coated with anti-rust oil and covered with a tarpaulin.

When using the mixer, you should also pay attention to:

1. Put the mixer in a stable position, install the machine feet, and level them up so that the machine can run freely.

2. Before using the mixer, add oil to the place where it needs to be oiled, and then run it without load to check whether all fasteners are loose, whether the electricity is normal, whether the machine is working normally, and repair and debug if there is any abnormality.

3. Turn the charging port to the top, open the charging cover to charge, and the charging amount must not exceed the specified amount. Then close the charging cover and start the machine to run. If any abnormalities are found on the way, please stop and check.

4. After working or changing varieties, rinse the hopper inside and outside the mixer.