1. When the new machine is running, the transmission belt is easy to stretch, and attention should be paid to adjusting the proper tightness of the belt to ensure the working life of the belt.

2. During the production process, the temperature rise of the bearing must be checked frequently. When the temperature rise exceeds 50°C, the machine should be stopped for inspection to find out the cause and eliminate the fault.

3. The main engine and graded flow bearings are grease lubricated, using No. 2 special grease,

4. The blades and linings should be checked frequently for wear. If they are worn out, the productivity will drop, and the particle size will become coarse. Replace them if they are found to be worn out.

5. Consumable parts should be checked frequently and replaced in time to ensure production quality and production volume.

6. The grease change period of the bearing is 2000 hours, and the filling amount of grease is 1/2 (upper measurement) or 3/4 (lower measurement) of the space in the bearing cavity. Do not fill too much grease, otherwise it will cause bearing temperature too high.

7. The grease change period of the screw feeder is 4000 hours, add ordinary calcium-based grease.

8. On the output shaft e, that is, the pulley e, avoid hitting with a heavy hammer to damage the parts.

9. It is strictly forbidden to turn the handwheel handle when the machine is stopped.

10. The lubricating oil used in this governor is N32 alkaline high-zinc type high-grade anti-friction hydraulic oil, and the reducer is 401 general lubricating oil, which must not be replaced by other machines.

11. After 3000 hours of use, new oil should be replaced, and then the oil should be changed for the second time after 500 hours of use, and then once after 1000 hours of use.