1. Equipment speed: The speed of the equipment is mainly adjusted by the frequency conversion controller. High speed will produce fine powder and slightly lower output value; if the speed is low, the material will be coarser and output value will be greater.

2. Equipment feeding speed: when the feeding speed is small, the equipment of the ultrafine pulverizer will not be saturated, and the interior of the pulverizer will not be saturated, so the particle size of the type product will not be as good as when it is running at full load, and the output value will not be as good as So high at full load.

3. Viscosity and humidity of the material: Some materials can become viscous or too viscous at high temperatures. During the milling process, such materials will not only simply stick to the inside or outside of the equipment, causing blockage of the discharge port, resulting in a decrease in sand output, and even some damage to the milling equipment in severe cases.

4. Hardness and fineness of raw materials: The particle size of the feed material during the grinding process is 3-5cm, lower or higher than this specification will directly affect the output value.