1. Operating procedures

1. Check whether there is oil in the lubricating place before starting the machine;

2. Carefully remove metal, sand, stone and other sundries in the material to prevent damage to the machine parts;

3. Operators are not allowed to put their hands into the feed port, and the machine cover is not allowed to be opened during operation;

4. The aperture of the sieve should be properly selected, and the damaged part should be riveted;

5. It is strictly forbidden to start the machine under load, and then feed the machine evenly after running for one minute, and inject proper amount of water when beating;

6. Before shutting down, idle for 2 minutes to remove the remaining material in the machine.

2. Adjustment and maintenance

1. The main wearing parts of super fine grinder: flat teeth, round teeth, large and small grinding teeth. The flat teeth and round teeth are made of fine steel, with good dynamic balance, and should be replaced if they are severely worn. The weight difference of each piece is not more than 1 gram, so as not to damage the bearing and the machine due to vibration;

2. According to the model and production, select a sieve that fits the rules. When replacing it, the smooth side needs to face down;

3. The bearings are filled with high-speed grease regularly, and checked once every half a month. If serious wear is found, it should be replaced or repaired in time;

4. Collision is strictly prohibited, and the inside and outside of the machine should be cleaned and kept properly to prevent rust if it is shut down for a long time.

3. Maintenance

1. Frequently check the fastening condition of each component to prevent it from loosening and falling off and damaging the machine;

2. The oil injection holes should be refueled frequently, and the bearing parts should be cleaned and filled with lithium-based grease every six months;

3. When shutting down for operation, the machine should be idling for a period of time, blow off the remaining material in the machine, and then shut down;

4. When the super fine grinder is out of service, remove foreign debris, add grease to all rotating parts, and store it in a warehouse with dry air and no corrosive gas.

4. Matters needing attention

1. The operator should stand on the side of the feeding port, and it is forbidden to extend the hand into the feeding port, and the machine cover is not allowed to be opened during operation or when the machine is not stopped;

2. It is strictly forbidden to start the machine under load. When the feeding port is blocked, it is forbidden to force feed it by hand or wooden sticks, and stop the machine immediately for inspection. When working, it is necessary to feed the material in an appropriate amount and evenly. If there are semi-wet materials that are not dry, they must be dried in the sun, or the amount of feed should be reduced.