1. Before crushing, check whether there are sundries and other materials in the grinding barrel, and remove them if any.
2. When crushing, do not mix materials with high hardness and particle size greater than 10mm. Materials with high moisture content must be dried or freeze-dried to reduce the moisture content below 12%.
3. Before use, be sure to check the fastening screws of the rotary support, which must be tightened. The silo must be clamped.
4. Please use appropriate voltage source to supply power, and ensure that the power line is intact, so as to avoid fire or injury.
5. In order to ensure the crushing quality, it is required to strictly control that the amount of each feeding shall not be less than 1/2 of the silo volume, and the feeding shall be carried out at a uniform speed by the feeding screw.
7. After long-term use, if the belt is seriously worn and the hose is damaged or leaked, it should be replaced in time.
8. After each operation of superfine crushing, make the machine idle for 2min, and pump the remaining materials.
9. In case of abnormal noise during operation, stop the machine immediately for inspection.
10. When replacing materials or stopping using for a long time, the grinding barrel shall be cleaned. The inner wall of the grinding barrel and the medium can be cleaned with starch, water, alcohol or other solvents, and then wiped with a dry cloth to ensure that the grinding barrel and the medium are dry,